QBK pneumatic diaphragm pump product introduction
QBK pneumatic diaphragm pump is a new type of pneumatic double diaphragm pump, has the advantages of long service life, no pauseetc, it is the flow of liquid can be pumped, and can supply some not easy flow of medium, has many advantages and suction pump,submersible pump, shield pump, pump mud and impurities such asconveyor mechanical.
QBK pneumatic diaphragm pump adopts compressed air as power source, for all kinds of corrosive liquid, with particles of liquid, high viscosity, volatile, flammable, poisonous liquid, all can be smoked light absorption, especially for flammable and explosive field.
QBK pneumatic diaphragm pump operation safe and reliable products, corrosion resistant, durable, with self absorption, idle non-destructive, a variety of materials, a wide range of uses, simple device.
QBK pneumatic diaphragm pump product advantage
1, Without irrigation water, suction lift up to 5m. to lift up to the pressure at the outlet of 70m. ≥ 6bar.
2, The flow is spacious, and good performance. To allow the maximum particle diameter of 10mm. Pumping mud, impurities, little wear on the pump;
3, Head, flow through the valve open to realize stepless adjustment(pressure adjustment in the 1 - 7 bar):
4, The pump has no rotary parts, no seals, moving parts, mediumdiaphragm pumps and other pumps and pump completely separated from the workpiece medium, the transmission medium does not leak out. Pumping so toxic, flammable or corrosive media,it will not cause environmental pollution and harm personal safety;
5, Do not have electricity. In the flammable, explosive use of safe and reliable place;
6, Can be immersed in medium:
7, Easy to use, reliable, open simply stopping to open and turn off gas valves. Because of unforeseen circumstances even if long timeno medium run or sudden stop pump will not result in damage, once the overload, pump will automatically shutdown, self protectiveperformance, when the load is recovered, and can automaticallystart running;
8, Has the advantages of simple structure, less wearing parts, thepump has the advantages of simple structure, convenient installation, repair, pump transmission medium will not come into contact with the valve, the rod and other moving parts, unlike other types of pumps due to the rotor, piston wear, gear, blades and other components to the gradual decline in performance:
9, Can deliver more viscous liquid;
10, This pump do not need lubricating oil, even if idle without anyeffect on the pump.
QBK pneumatic diameter pump product feature
1, As with air powered, so with the back pressure flow (exports resistance) changes in the automatic adjustment, suitable for use in high viscosity fluid. The centrifugal pump operating point is set as the base water good, if slightly higher viscosity of the fluid used, you need to complete reducer or frequency converter, the cost will be greatly improved, and the gear pump is the same.
2, In the inflammable and explosive environment pneumatic pump with reliable and low cost, such as fuel, gunpowder, explosives,transportation, because: first, could not produce sparks after grounding; no heat second, work, machine not overheating; third,the fluid does not overheat because the diaphragm of the fluid a minimum of agitation.
3, At the site where the poor, such as construction sites, factories discharge waste water, due to the impurities and water composition is complicated, easy to plug the pipeline, so the pump on the formation of excessive load, the electrical heating vulnerability. Gasand flow through the particles adjustable diaphragm pump, pipe plug to open automatically when to stop.
4, Another small easy to move the diaphragm, without foundation,the ground is extremely small, easy to install and economic.Materials can be used as portable pump.
5, In the material treatment harmfulness, corrosive, the diaphragm material can be completely separated from the outside world.
6, Can be used for conveying fluid, the chemical nature of the relatively unstable as: photographic materials, such as flocculation liquid. This is because the diaphragm of the low shear stress, the physical impact of the material of small.
QBK pneumatic diaphram pump main parameter
Traffic: 0-30m3/h;
Head: 0-50m;
Aperture: 10-100mm;
Temperature: -15-+150 ℃;
Pressure: 0.1-0.7MPa;
Self suction height: 5-7m.
No comments:
Post a Comment